Greetings All,
Here are a couple I just finished up. It is my first attempt at cut out patterns and I think I'm going to keep doing it like this. It was a lot of fun tinkering around with it.
I won't go into any details as I'm sure you all know how to do it.
They are Goncalo Alves and Bocote, with maple as the veneer.
(http://i253.photobucket.com/albums/hh53/sharkathmi/20090206001.jpg)
I learned how much clamping pressure to use when I was gluing up the first one. :rolleye:
As you can see I cracked off the bottom of the darker call. I "repaired" it by adding the bocote on the bell.
(http://i253.photobucket.com/albums/hh53/sharkathmi/20090206003.jpg)
Thanks for lookin' and as always, comments welcome.
Mark
No, I dont know how ya did it :nono: But I sure do like it.
For a beginner you sure are taking off. There's a few call makers that been at it for years and can't produce anything close to that.
Very nice work :yoyo:
They look great .
Super job :congrats:
:yoyo: Very nice work! :yoyo:
I like it! :yoyo: :yoyo:
Excellent looking lamination. I also like the lines of your calls. Personally, I like the Bocote on the bell of the call. Extra work, but I like it.
Jerry
Well Thank You everyone!! :bowingsmilie:
I've had fun doing them. I'm looking forward to getting a band saw so I can do more.
I paid $20 to have those four cuts made :shck: We discussed cost after we were done cutting :doh2:
Hawks Feather, that ring in tenon fit too!! Not just a butt joint. I'm learning! :biggrin:
Mark
purdy cool!!
Real nice.
man those are some SWEET lookin calls I really like the Bocote on the bell is my favorite too nice stuff
Those look great. :yoyo: You sure are getting it figured out in a hurry. :highclap:
I'm with Jim, I don't know how to do laminates like that either.
Jim, CB...and anyone who's interested.
To do call bodies like this is easier than it may look.
I took two call blanks cut to the same dimensions and glued them together with two little dots of glue, because they have to come apart later. Trace the pattern you want on the top piece of wood (stacked vertically) and cut it out on a band saw. Break the pieces apart and exchange the middle piece to the other body. I know you can use a clamp to hold the pieces together but gluing was easier and I wouldn't have the clamps to get in the way. When you glue them up I used a contrasting laminate in between the pieces. I made my laminate by cutting thin pieces on the table saw using a carbide blade. :rolleye: That's why they are different thicknesses as you can see in the calls :doh2: Anyway, carefully glue and clamp and you will have two pretty cool blanks when you are done. The next time I do this I will move the pattern up a little bit so I am not so close to the bottom. I think that is why the end broke off is because it was too close to the end and too thin.
If you have a scroll saw, there is a great post by Hunt-n-carve (I think) that shows you how to something similar, only it's so exact that you don't need any laminate between the woods. It's really cool to see.
Thanks for the kind words and your support everyone. I appreciate it.
Mark
Very Nice Mark...I haven't done a laminate in quite a long time. I do know how to do them I just can't seem to find the time to play with anything like that. The guys on here are right...for a beginner you sure learn fast and your calls are looking good - keep it up.
Steve